Proudly serving Boynton Beach Call for a free estimateCall (561) 903-1024
Keystone Garage Door Repair Co.Boynton Beach, FL (561) 903-1024

Garage Door Cable Repair Serving Boynton Beach, FL

A garage door hangs from two steel cables, one on each side, which lift the weight when the springs wind or unwind. When one frays or snaps, the door jams or drops. If you spot a loose, frayed, or hanging cable, here is what the fix involves.

Fast Scheduling

Tap to Call (561) 903-1024 Request a Free Quote →

Fast Scheduling

(561) 903-1024
  • Free Estimates
  • One crew from start to finish
  • You approve the scope before we start
  • No surprise charges
Book a Free Quote

Quick call, honest answer, the form works too.

Get My Quote

Locally operated

Call (561) 903-1024

We'll give you a call back during business hours.

Send this and a local provider gets your details so they can contact you about your request. We don't sell your information. See our Privacy Policy.

By entering your phone number, you're OK with us and the local provider texting you about your request. Message frequency varies; msg & data rates may apply. Reply STOP to opt out, HELP for help. See the SMS section of our Privacy Policy.

What the cables do

The springs store the energy, and the cables carry it to the door. Each cable runs from the bottom of the door up to the lifting hardware so the two sides rise together. If one side loses its cable, the other side does all the lifting. The door tilts, binds in the track, and can twist the sections. A cable rarely fails in isolation. It frays from rubbing, or it snaps because the door has been out of balance for a while and one side has been working harder. We fix the cable and find out why it failed.

What a homeowner usually notices first

Sometimes a cable failure is loud, with a bang from the garage followed by a door that will not open. More often, one corner sits lower than the other, the door shudders on the way up, or a cable hangs slack beside the track. Stop using the opener immediately. Running the motor against a door missing a cable can bend the track and warp panels. Do not try to lift a stuck door by hand. It is unevenly supported and can fall. If the door is stuck open, it leaves the garage exposed. Boynton Beach gets about 57.2 inches of rain annually, with the rainy season running from May to October. September peaks around 8.4 inches, while December is the driest at 2.2 inches, so a gaping door needs immediate attention.

From the side

Checking balance before we touch the cable

Before any parts come off, we disconnect the opener and lower the door halfway to check balance. A properly balanced door should stay in place. If it creeps up or drops, something in the lifting system is off. With the opener attached, the motor can mask a problem by dragging the door along. Disconnecting it reveals the actual condition of the lifting system. When the door cannot be moved at all because a cable is already gone, we secure it first and judge balance once the new cable is installed.

How the repair goes

We secure the door so it cannot move, release the failed cable, check the drum or pulley it rides on, and fit the new one. A new cable running over a damaged surface will fray again, so we inspect the brackets and hardware. We use a socket wrench kit to handle the bolts on the brackets and a drill with drill bits for fasteners that need to be redone or set properly. Once the cable is on, we reconnect the opener and run the door. Finally, we check the opener's photoelectric eyes and auto-reversing function. The door should reverse when the beam between the eyes is interrupted.

What cable repair costs

We charge $100 to $350 per garage door cable repair. A single frayed cable on an otherwise sound door sits toward the lower end. If the hardware the cable attaches to is damaged, the job moves up because there is more to fix. We provide an exact number after inspecting the door. If both cables are original and one just failed, we will check the other for wear so you can decide if it needs replacing.

How It Works

  1. Call or Text

    Tell us what you're seeing and when it started, you'll get a straight answer, not a sales pitch.

  2. No-Pressure Inspections

    We come out, measure what's actually happening, and walk you through what we find.

  3. Know the Price First

    We put the fix, the timeline, and the number on paper, take your time with it.

  4. We Do the Work

    Our crew does the work, checks it, and leaves the site clean. You see everything we did.

Depending on what we find, that can mean:

  • During maintenance, tighten loose rail and roller fasteners, check cables for wear or fraying, and lubricate rollers and springs with garage-door lubricant.
  • With the door down, inspect hinges, rollers, fasteners, tracks, panels, springs, cables, and weather seals for visible damage or wear.

Pricing Ranges

These are planning ranges. Nothing is final until it is in writing.

Garage door spring replacement

$150–$350

You Might Also Need

Serving Boynton Beach and Nearby

Serving Boynton Beach, FL. Call (561) 903-1024 to confirm coverage for your address.

The Facts Behind the Number

  • Free EstimatesYou pay for work, never for the quote.
  • One crew from start to finishNo rotating faces, the same crew, all the way through.
  • You approve the scope before we startThe work matches what you agreed to, line for line.
  • No surprise chargesThe bill matches the quote, extras get your OK first.
(561) 903-1024 Get a Quote →

← All Garage Door Repair in Boynton Beach